Another Serials Label Email

[Kwong Li <kwong dot li at library dot ucsf dot edu>]

I too would like to add to the serials label discussion (you would think 
that such a task would not be so ultra complicated, but...).  Here at UCSF 
we print out the Spine and Pocket labels for serials using Print Wizard on 
Demco Paper Processing Labels (1 5/8"H x 9/10"W Spine and 1 5/8"H x 2 
9/10"W Pocket).  Out INNOPAC label spec settings are:

width of spine in columns - 8
width of label in columns - 28
width of gap in columns - 3
height of label in lines - 8
vertical space bet/label in lines - 1

And I am finding that getting the Print Wizard settings to fit the text 
inside the label with no cutoffs for more than one sheet is next to 
impossible.  Is anyone else out there also printing the same serials labels 
and using the same Demco Labels and printing with success?  If so, I'd like 
to know.  Many thanks in advance.

kwong


~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
kwong li
Innopac and Applications Coordinator
Library -- Center for Knowledge Management
University of California San Francisco CA 94143-0840

415.476.1116
kwong dot li at library dot ucsf dot edu